Panasonic KX-F590 - Manual (Page 54)

Troubleshooting and Maintenance
Troubleshooting
Error messages on the display
If the unit detects a problem, one of the following messages will appear on the display.
ERROR MESSAGE CAUSE AND REMEDY
CHECK COVER
•The top cover is open. Close it.
CHECK DOCUMENT
►The document is not fed into the unit properly. Re-insert the document.
If the misfeeding occurs frequently, clean the document feeder rollers
and the sub roller inside the unit (see page 59). Still it remains
unsolved, adjust the feeder pressure (see page 58).
CHECK MEMORY
»Memory (phone numbers, parameters, etc.) has been erased.
Re-program them.
MECHA ERROR
»Mechanical error occurs. Open the cover and re-install the recording
paper. Then press the STOP button and close the cover.
NO RESPONSE
•The receiving unit is busy or out of recording paper. Try again.
OUT OF PAPER
•The unit ran out of recording paper. Replace it (see page 8).
PAPER JAMMED
POLLING ERROR
REMOVE DOCUMENT
TRANSMIT ERROR
UNIT OVERHEATED
►The recording paper is jammed. Clear the jammed paper (see
page 57).
►The other unit does not provide the polling function. Check the other
party.
•The document is jammed. Open the cover, remove the jammed
document (see page 58) and try again.
•Attempted to transmit a document longer than 600 mm (235/6"). Press
the STOP button and remove it (see page 58).
•Transmission error occurs. Try again.
►The unit is too hot. Leave it as it is and allow it to cool down.
54