Panasonic PT-51G40 - Manual (Page 38)

Auto Program
Displays and Exits Menus
CZiQ.
ACTION
Auto Programming
- The Auto Programming
feature allows you to place all channels with a video
signal into Channel Scan Memory when you press the
CHANNEL UP or DOWN button
NOTE: Antenna (TV or Cable) Tuning mode must beset
properly for your system
1 Press the ACTION button to display the Mam Menu
2 Press the CH UP/DOWN and VOL LEFT/RIGHT
button to highlight the Set Up Icon
3 Press the ACTION button to display the Set Up
Menu
Located On Remote Control
S b I bc I s nr Adjusts
Features When
Menu IS Displayed
SET UP SETUP
SETTIME В 23 AM
SET DAY SUN
ANTENNA CABLE
AUTO PROGRAM1 ГмВ"
MANUAL PROGRAM NO
4 Press the CH UP or DOWN button to highlight
"AUTO PROGRAM"
5 Press the VOL LEFT or RIGHT button to start Auto
Programming Scan Channels will automatically
advance until all channels have been scanned
" Channel numbers with video signal present will turn
blue which indicates stored in Channel Scan memory
6 Press the ACTION button twice to exit
NOTE: Some channels with very weak signals may be
locked into memory These must be deleted
manually using the Manual Program feature
Helpful Hints:
After Auto Programming:
Blue channel number indicates channel is in Channel
Scan memory
All channels are available by direct access using the
Keyboard numbers “□ through 9"
After Auto Programming Scan has completed, up to 15
channels will be programmed into the FAVORITE
Channel Scan if space is available Any original
channels that were programmed into FAV CHANNEL
will remain (Refer to Favorite Channel Scan for
deleting unwanted channels )
- 3 B -