Panasonic OMNIVISION PV-8453 - Manual (Page 21)

l^c
Check list before you begin.
Q Clock is set to correct time.
Time Stamp Feature
For about the first 10 seconds of each recording, the VCR automatically writes
the following program data on the tape: Date, Start time, Scheduled stop time
(for Timer Rec. only), Channel No. and Category (for Timer Rec. only). Then,
if playback is started at the starting point of the recording, this information will
be displayed about 7 seconds after playback begins for a few seconds.
2
3
b
C
NOTE
When the VCR is
connected to a
Combination VCR
which has a Blue Back feature,
even if the VCR Blue Back is set
to “OFP on the VCR, the screen
will go to blue back.
1
Press ACTION
to display the menu.
^ Press
AW to select “SET UP
FEATURE,”
and then press
► to
display the “SET UP FEATURE” screen.
3
Press
► to select “ON” or “OFF.”
• When “OFP is selected, the program data is
written on the tape, but will not be displayed
for the first 5 seconds of playback.
SET UP VCR
SET UP FEATURE
SET CLOCK
SET UP CHANNEL
ID lOMA/ LANGUE: ENGL I SH
SELECT:* T KEY
SET :► KEY
END :ACT I ON KEY
----- SET UP FEATURE ---
: off
SET
END
;► KEY
: ACT ION KEY
Press ACTION twice
to exit.
Stamp Example>
Normal/
One Touch Recording Timer Recording When Clock is not set.
12/28/1998 MON
12:00PM
CH 08 ABC
12/28/19ЭВ MON
12:00PM - 1:00PM
CH 08 ABC SPORTS
If the tape speed is changed immediately after recording begins,
the display may be incorrect.
Blue Back ON/OFF Feature
You may choose whether or not you want the VCR to display a solid blue
back screen when the broadcast signal is very weak.
3 Press ACTION
to display the menu.
b Press
AW
to select “SET UP
VCR,”
and then press
► to
display the “SET UP VCR” screen.
C Press
AW
to select "NOISY CH
BLUE BACK,”
and then press ►
to select “ON” or “OFF.”
SET UP FEATURE
SET CLOCK
SET UP CHANNEL
ID I ОМА/ LANGUE: ENGL I SH
SELECT:* ▼ KEY
SET :► KEY
END :ACT ION KEY
-------- SET UP VCR ...........
REPEAT PLAY
BEEPER
NOISY CH BLUE BACK
; OFF
: ON
: ON
SELECT
.SET
‘END
*
W
KEY
► KEY
ACTION KEY • When “ON” is selected, a solid blue screen
appears whenever the signal is weak or __
nonexistent. When “OFP is selected, the
picture is displayed regardless of the signal condition.
• The picture can not always be seen clearly when “OFP is selected.
Press ACTION twice
to exit.
21