Panasonic OMNIVISION PV-8453 - Manual (Page 14)

^Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
Function & Channel Display
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
(Some Station names may
also appear if Channel
Caption is set. See page 20.)
Menu Screen
------------MENU--------- *-
iJ^ATURE
SET UP CHANNEL
IDI ОМА/ LANGUE: ENGL I SH
SELECT
SET
END
A ▼ KEY
► KEY
ACTION KEY
1 Press ACTION*
to
display the menu.
2 Press
AT
and
► to
make your selection.
• To get the most from each feature,
please read the Operating Manual
before attempting any operation.
VCR Status & Clock Display
Press DISPLAY
to display or remove the
overlay shown below.
Function
Status
Ree Time
Remaining
(OTR mode only
see page 16.)
Current Time
Channel Caption
(See page 20.)
•REC 12:OOAM ABC
-0:25 -0:12:34
► STEREO SP
► SAP
MONO
Broadcast Audio
Being Received
(See page 26.)
• This display will
disappear in 5 seconds.
Counter
Tape Speed
(See page 5.)
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up in
Play mode, or when the selected channel has no
broadcast signal with the Blue Back ON/OFF
Feature (page 21) set to ON, the TV screen will
turn solid blue.
Warning and Instruction Displays
These displays wilt alert you of a missed operation or
provide further instructions.
If no active channels are found
for CHANNEL MEMORY...
(See page 12.) .
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 18.)
After a Timer Program has
been set...
(See page 18.)
If you press REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(See page 16.)
If you press PLAY, FF, REW,
or REC on the remote
control or VCR without
a cassette inserted...
(See pages 1 5 , 1 6 . )
If you press POWER or STOP
during a Timer Recording...
(visible in VCR mode only)
(See page 1 9 . )
If head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
If you press a function button
other than STOP/EJECT or
POWER while the VCR is in
VCR Lock mode...
(See page 22.)
If you press POWER, ACTION,
or PROG on the remote while
in TV or CABLE/DSS mode...
(See pages 28, 29.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCR OFF
FOR TIMER RECORDING
CHECK CASSETTE
RECORD TAB
NO CASSETTE
PLEASE INSERT A CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
VCR LOCK ACTIVATED
NOW TV/CABLE/DSS MODE
PLEASE PUSH VCR KEY
ON REMOTE
14