Timer recording, To enter more programs, Nesb – Panasonic OMNIVISION PV-8453 User Manual
Page 18: I^^check list before you begin
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Timer Recording
•Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
You can set up the VCR to record a one
time, daily, or weekly program while you are
away or otherwise occupied. Up to 8
programs can be stored in memory.
I^^Check list before you begin.
□ All connections are made.
(See pages 6~9.)
n TV and VCR are plugged in and turned on.
n VCR/TV selector is set to “VCR."
□ Clock is set to correct time.
Q Record tab in place. (See page 5.)
Multi Function Display
1
4
♦
5
1
Press PROG* to display the
program screen,
• If a program is already in memory, press
AT
and ► to select an unused program number.
START STOP CH
SELECT
SET
END
Press
AT
and ► to select and
set one of the following as the DATE:
• 1-31 ^Onetime recording
• DAILY =Same time MON-FRI
• WEEKLY (SUN~SAT)=Same time once a week
micr\
CATEGORY:N/A
SELECT START DATE
A T IÍEY
► KEY
PRCXi KEY
—
2
................
6
Example
9.............. '31
1
Today’s Date_______ 7
SELECTA
/T
Selection Order
DAILY
(^WEEKLY.................. .WEEKLY________ WEEKLY ^
(SAT)
(MON)
(SUN)
3
Press
AT
and
to select and set each
of the remaining
items at right.
Remaining Items to be set:
• START time
• STOP time
• CH(annel) number, or LINE
for outside source recording
• Category (N/A [not applicable],
SPORTS, MOVIE, COMEDY,
MUSIC, DRAMA)
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly press ► to move the cursor to the right, or
M
to
move to the left to the incorrect entry and make the correction.
4
Press PROG to end the program.
• This screen appears for confirmation.
To Enter More Programs
Press
AT
and ► to select and set a blank
program number, and then repeat steps 2 and 3.
Press PROG to exit this mode.
P OT START STOP CH SPD
2--------
4--------
CANCEL
SELECT
ENTER
END
ADD/DLT KEY
I-8;A ▼ KEY
*■
KEY
PROG KEY
G
Press POWER off to set the timer.
• When recording programs via a cable box,
make sure the cable box is left ON and
tuned to the desired channel.
X I ^
-nESB-
^ I ^
Multi Function Display
A cassette with no record tab is ejected and "TIMER" flashes when the power is turned off to set the timer.
If the start times of two programs overlap, the lower numbered program wit! have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 16),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording will not be performed or continue.