Panasonic PANAFAX UF-550 - Manual (Page 38)

► Customizing Your Machine
No. Parameter
Setting
Number
Setting Comments
17 RECEIVE MODE 1 Manual Setting the reception mode either automatic or manual.
2 Auto
22 SUBSTITUTE RCV 1 Invalid Selecting whether or not the machine receives to memory when
recording paper runs out, toner runs out or recording paper
jammed. 2 Valid
23 RECORDING PAPER
SIZE
1 A4 Setting the recording paper size installed in your machine.
(UF-550only)
2 Letter
3 Legal
24 PRINT REDUCTION
1 Fixed
Selecting print reduction mode.
Fixed: Reduce received document according to setting of
Parameter No. 25
2 Auto
Auto: Reduce received document according to the length of
received documents.
25 REDUCTION RATIO 70 70% Selecting fixed print reduction ratio from 70% to 100%. This
parameterfunctions only when fixed print reduction is selected
on fax parameter no. 24.
... ...
100 100%
26 POLLING PASSWORD (....) Setting a 4-digit password for secured polling.
27 POLLED FILE SAVE 1 Invalid Selecting whether or not the machine retains the polled
document in memory even after the document is polled once.
2 Valid
28 STAMP AT MEM. XMT 1 Invalid Selecting whether or not the machine stamps the original
documents when storing the documents into memory,
(depending on the Stamp setting on the Control Panel.)
2 Valid
30 DRD SERVICE 1 Invalid Selecting whether or not the machine is available ”DRD
Service”. If tills parameter is set to "Valid”, your machine detects
2 Valid
the specified ring pattern only to receive a document
automatically
31 INCOMPLETE FILE
SAVE
1 Invalid Selecting whether or not the machine retains the document in
memory if the document is not successfully transmitted.
2 Valid
32 COPY REDUCTION 1 Invalid Selecting whether or not the machine performs copy reduction in
accordance with the setting of Parameter No. 24 and 25.
2 Valid
33 XMT REDUCTION 1 Invalid Selecting whether or not the machine performs reduction when
thetransmitting document iswider than the recording paper used
at the receiving machine. (UF-770 only)
2 Valid
34 POWER SAVE TIMER
- Start-Time
To reduce the power consumption of the machine in standby,
select the time period to turn off the high temperature fuser unit
when the printer is idle.
-- End-Time
Factory default is always ”ON” (When Start = 00:00 and End =
00:00).
Continued on the next page.
36