Panasonic OMNIVISION PV-DM2799 - Manual (Page 25)

VCR Plus+ System Programming
Process of Recording 1
Connection i=> Setup O Programming
Display PROGRAM
screen.
Press PROG.
2 Select VCR Plus+ PROGRAM.
1) Press
AT
to
select.
2) Press SET to
display.
3
PROC
VCR PI us + PROGRAM
ENTER PLUSCODE NUMBER
ENTER : 0-9
END : PROG
Enter PlusCode
programming number.
1 ^ PrP*iii
NUMBERED
keys.
2) Press SET
when finished.
O © ©
© © ©
© © ®
©
To Make Corrections
Press M repeatedly to delete the PlusCode programming
number.
4
VCR PIUS+ PROGRAM
ENTER PLUSCODE NUMBER
123
DAILV(MON-FRI)
WEEKLY
Set Record Frequency.
1) Press
AT
to
select.
2) Press SET.
5
VCR Plus+ PROGRAM
DATE STAfil STOP CH M
4FRI lO# l2:00A0e H
TODAY
SELECT : . » SET : SET
END : PROG BACK: ^
Select Recording speed.
{See page 6.)
1) Press
AT
to
select.
2) Press SET.
6
7 Exit this mode.
Press PROG twice.
• PROG TIMER indicator lights on
the unit.
\^C Check list before you begin.
n The clock is set to correct time.
O VCR Plus+ System Setup is complete
(See pages 23, 24.)
-| PROG
6
3
NUMBERED
Keys
2
SELECT
4^^
2 SET
5
Use normal Timer Recording steps if:
• a program PlusCode programming
number is not listed.
• program, such as a sporting event, may
run over scheduled stop time.
See page 21 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
You can obtain unlisted PlusCode
programming numbers by calling 1-900-
454-7587. Call costs approximately $.95
per minute.
Avoid overlapping program times.
If you’re using a cable box, make sure
that it is turned to the desired channel
and the power is left on for timer
recording.
25