Panasonic OMNIVISION PV-DM2799 - Manual (Page 20)

Timer Recording
You can set up to 8 programs to be recorded while you are away.
Display PROGRAM screen.
Press PROG.
2
3
4
VCR Plus
ilBHi
ON TIMER
SLEEP TIMER
PROGRAM
Select TIMER PROGRAM.
1) Press
AW
to select.
2) Press SET to
display.
H a program is already in memory,
press AT, and SET to select an
unused program number.
TIMER PROGRAM
mu START STOP CH SPD
- - - - - - SIP
TODAY
SE LECT : * »
END ; PROG
Set the recording DATE.
1) Press AT
to select.
2) Press SET (or
M ) to set.
• 1-31 = One time
• DAILY = MON-FRt
•WEEKLY SUN-SAT
= Same time once a
week
Example r
8-9- '31— 1 —2’
Today’s — 7 SELECTA/V Selection Order DAILY
Date
I
I. WEEKLY WEEKLY WEEKLY
(SAT) ....... (MON) (SUN)
Repeat step 3 to set:
• start time, stop time
• Channel (or LINE for outside source)
• Speed (SP, LP, SLP)
PRoa
T I MER PROGRAM
DATE START STOP 0\ SPD
4 fl:00P 9 j 30P 08 SP
SELECT 18:* ’ ENTEH:SeT
END : PROG CANCEL ADtVDLT
End the program.
Press PROG.
To Enter More Programs
Press
AT
and SET to select
and set a blank program number,
and then repeat steps 3 and 4.
Exit this mode.
Press PROG twice.
• If you’re using a cable box, make
sure that it is turned to the desired
channel and the power is left on for
timer recording.
• PROG TIMER indicator lights on
the unit.
□ All connections are made (See page 9.)
□ Your unit is plugged in.
n The clock is set to correct time.
D The tape is long enough.
D The record tab is in place.
Check list before you begin.
PROG
4
5
2 SELECT
. AT^
3
2 SET
■
3
20
2 minutes before Timer recording is
performed, "PLEASE PREPARE FOR
TIMER REC" appears and/or the PROG
TIMER indicator flashes. Be sure a
cassette with record tab is loaded and the
unit is in stop mode.
If the start times of two programs overlap,
the lower numbered program will have
priority.
If the start time for a Timer Recording
comes up during a normal recording or
One Touch Recording (page 17), the
Timer Recording will not be performed.
If there is a power interruption of more
than one minute, the recording may not
be performed or continue.
If "INCOMPLETE" appears after all items
have been set, check all entries and make
necessary corrections.
For assistance, call 1-800-211-PANA(7262)