Electrical connection, Fotnrt ss^), Cq-vx999ew (rear view) – Panasonic CQ-VX999EW User Manual
Page 47: Before wiring connection
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Electrical Connection
Before Wiring Connection
Note :
For instailaiion in cars with trip or navigational computers, ali electronic memory settings previously
registered in the computer will be lost when the battery terminal is disconnected. Do not disconnect the
battery in vehicles equipped with these units. Therefore, extra care should be taken to prevent short-
circuits.
® This unit can be connected to an optional CD changer (CX-DP801 EN). For details, consult your nearest
Panasonic dealers.
® For connection to a CD changer, refer to the operating instructions of the CD Changer (CX-DP801 EN).
Caution :
® To prevent damage to the unit, be sure to follow the connection diagram as follows.
® Remove the covering of the leads about 5 mm long from their end before connecting.
® Do not insert the power connector into the unit until the wiring is completed.
® Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all
cables and keep cable terminals free from touching any metal parts.
CQ-VX999EW (Rear view)
Wiring Accessories
Accessory
Quantity
Power Connector
1
Radio Antenna Jack
O D O O O O O O T ^
0 0 0 0 0 0 0 0
o o o o o o o o c ^
Power Connector
Eo-antenna Control Power Cord (A NT-CO NT MAX0.1 A)
5nnect it to ihe auto-antenna
ni3==cn
...................
ìtrol power cord of thè car.)
(Blue)
Caution:
Do not connect the auto
antenna control power cord
directly to the power terminal
for driving the auto-antenna.
(Otherwise,
it
may
cause
trouble. )
{ILLUMINATION)
=czi==CZ
Illumination Cord
(Orange w/white stripes) ----------------------------------------------
f
Connect NAVI cord to
Panasonic navigation NAVI
(NAVI MUTE)
f~
\
Connect the illumination cord
to the power line which is
connected to the clearance
lights of the car.
mute cord.
NAVI Mute Cord
GROUND
(Connect to a metallic part
of the car.)
^‘^'^^ssories Power Cord
(Connect it to the ACC power
connector of the car.)
Connect the battery power cord to
a terminal which is always live.
Twin CD Changer (™IN CD.C-CONT)
foTnrt Ss^)
(White w/black stripes)
(FRONT L)
(White) [f
(BATTERY 10A)
Battery Lead
(Yellow) Fuse"(10A)
(Connect to car battery)
External Amplifier Control
Power Cord (Connect it to
an external amplifier.)
(Green w/black stripes)
(Violet w/black stripes)
Front Speaker
(left)
Front speaker
(right)
Rear Speaker
(left)
Rear Speaker
(right)
47
CQrVX999EW