Panasonic NV-F70EA - Manual (Page 43)

DUBBING (COPYING)
Dubbing (copying) from one video cassette to another.
•To assure smooth, noiseless cuts when interrupting
the recording, always use the Pause/Still Button
(ID-
•To obtain smooth cuts when starting the recording
from the stop mode;
1. Play back the last part of the previously re­
corded material to confirm its ending point, and
then press the Pause/Still Button
(I I).
2. Press the Record Button (•).
(The VTR is still in the pause mode.)
3. To start recording, press the Pause/Still Button
(II) again.
•The picture quality of a re-recorded tape is not as
good as that of the original.
Stereo Type PHONO Cable
(Supplied)
Preparation
• Make the necessary connections as shown in the connec­
tion diagram.
• Press the VTR On/Off Switches to turn both VTRs on.
•Set the input Signal Selector to “Line/Audio”.
(Recording VTR)
• Make sure that the Noise Filter/Edit Selector of both the
recording and playback VTRs (if equipped) are in the
“EDIT ON” position. Set these switches to “OFF" for or­
dinary use of the VTRs.
(The Noise Filter/Edit Selector is on the front panel.)
^ Place the recorded cassette in the playback VTR and a
blank video cassette with the erasure prevention tab
intact in the recording VTR.
0 Press the Record Button (•) on the recording VTP
e
Press the Piay/x2 Button (►) on the playback VTR.
Q Press the Stop Button (■) on both VTRs to stop the
dubbing.
43