Panasonic TC-43P15 - Manual (Page 24)

Tuning Procedure
Automatic Tune (Ctiaraiel Select and Regional System must already be se^ Refer I d pages 20 to 23)
1,6 2,4 3
(TV set)
This TV uses automatic tuning to determine whether or not a broadcast signal is being sent which
it can receive, and automatically prepares so that the channel selection can respond to both the
position select and direct select modes.
1
PRE.
Push the “PRE.” (PRESET)
button 3 times.
P R E S E T 1
C H 1
C H S E L E C T P O S .
S V S S E L E C T R S I P / K . E .
n U T G T U N E
H R N U f lL T U N E
S O U N D S Y S 5 . 5 M H z
C O L O U R S Y S R U T O
F IN E T U N E
S K I P
O F F
Automatic Search “AUTO
TUNE” Condition.
Push the Volume Up or
Down button. AUTO TUNE
Search Start.
The best tuning position is
automatically memorized.
V A
After all stations are tuned,
the on-screen display will
automatically change from
“AUTO TUNE” to "SOUND
SYS” Position. Confirm the
sound condition of each
Programme Number by using
the Programme Number Up
“ a " button.
1 1 P R E S E T I
C H 1
C H S E L E C T
P O S .
S Y S S E L E C T R 5 IR /M . E .
R U T O T U N E
H f lN U R L T U N E
B O U N D S Y B 5 . B H H z H
C O L O U R S Y S R U T O
F IN E T U N E
S K I P
O F F
If the Sound is not clear or
no sound is produced on a
Programme Number, then
follow the next Step 4.
Note:
When sound volume is too
small to confirm, turn it up by
using the sound volume
button on the remote control.
“ +
24
If necessary, push the
Volume Up "+” or Down
button, to improve the Sound
quality.
1 1 P R E S E T 1
C H X
C H S E L E C T
P O S .
S Y S S E L E C T f iS I R / M . E .
R U T O T U N E
M R N U R L T U N E
S O U N D S Y S 5 . S M H z H
C O L O U R S Y S R U T O
F IN E T U N E
S K I P
O F F
The sound indicator will
change as follows.
4.5MHz <---------- > 5.5MHz
t
t
6.5MHz ------------> 6 . 0 MHz