Panasonic WJ-SQ508 - Manual (Page 20)

5. Master/Slave operation without VTR
SPOT/SEQ OUT
(A)
ALARM/SEQ OUT
Master/Unit No.l
bODDODCOQ
6 ood 6 obbo
iiSiSsss'isiTTiTTiWi
S+I
5 ST „
(B)
---------------IK
Slave/Unit No2
bOODDOObe
bOOOOODbC
m h
S 8 T
(C)
J ll
Slave/Unit No.3
ooooooDde
boodoodbc rST ®
68 T
#SSiiiSiii:srmTTTTTTTTTTTTTTTTl
(g) Single alarm mode:
( 1 ) SPOT/SEQ OUT —> continues a previous
operation.
{ 2 ) ALARM/SEQ OUT -» Alarmed WJ-SQ508 fixes to
alarmed picture.
(h) Multiple alarm mode:
( 1 ) SPOT/SEQ OUT —> continues a previous
operation.
( 2 ) ALARM/SEQ OUT —+ Alarmed channels start
sequencing out once every second.
(i) Quick Scan alarm mode:
( 1 ) SPOT/SEQ OUT continues a previous
operation.
( 2 ) ALARM/SEQ OUT Alarmed WJ-SQ508 starts
sequencing out all pictures in QS-TIME.
(a) Sequence time: Depends on Dwell Time Control (5) or
programmed sequence time.
(b) Controls:
(1) Master/Slave Switch (27) to Master position for (A)
WJ-SQ508, to Slave position for (B) (C) WJ-SQ508.
(2) Station Number Switch (29) should be same,
(3) Unit Number Switch (30) to 1 for (A) WJ-SQ508,
2
for (B) WJ-SQ508 and 3 for (C) WJ-SQ508.
(4) Dwell Time Control (5) set to desired time for (A)
WJ-SQ508. Not specified for (B) (C) WJ-SQ508.
(c) System stops when the power of (A) WJ-SQ508 is
turned off. When the power of (B) WJ-SQ508 is turned
off, no picture is supplied from (C) WJ-SQ5O0.
(d) Normal sequence mode:
( 1 ) SPOT/SEQ OUT —> All cameras are switched by
Dwell Time Control (5) of (A) WJ-SQ508.
(2) ALARM/SEQ OUT —> All cameras are switched by
Dwell Time Control (5) of (A) WJ-SQ50a
(e) Program sequence mode:
( 1 ) SPOT/SEQ OUT ^ Program
performed for each, WJ-SQ508
program.
(2) ALARM/SEQ OUT —> Program
performed for each, WJ-SQ508
program.
(f) Spot mode:
(1)
SPOT/SEQ OUT Spot picture
WJ-SQ508 is obtained.
(2) ALARM/SEQ OUT —» Continues the sequence
mode.
sequence is
with it’s own
sequence is
with it's own
from any
- 2 0 -