Panasonic PV M939 - Manual (Page 39)

Operation Differences Using AC or DC Power
This Combination VCR is equipped to be operated on either AC or DC power. However, there are some
differences in Combination VCR operation depending on which power supply is used.
The Combination VCR will accept commands from the remote control only when POWER on the Combination VCR is
turned ON (POWER indicator is lit.)
When POWER on the Combination VCR is OFF (DC power source), it's the same as if the Combination VCR were
unplugged. Therefore, all memory data, i.e. clock data, etc, is erased in approximately one minute.
If there is a loss in battery voltage of more than 30 seconds, the Combination VCR automatically shuts off. When normal
voltage is restored, pressed POWER on the Combination VCR OFF and then ON.
AC Power Supply is Used
Power Switch is ON on the Unit
DC Power Supply is Used
Power Switch is ON on the Unit
• If POWER on the remote control is pressed OFF
during rewind, the power will shut off but the
rewind will continue (Memory Rewind.) If it is
pressed during recording, the recording will
continue.
• If POWER on the remote control is pressed OFF
during rewind, the rewind is terminated and the
Combination VCR shuts off. If it is pressed while
recording, the recording is terminated and the
Combination VCR shuts off.
• It takes from 3 to 5 minutes to rewind a two hour
tape.
• It takes 5 minutes to rewind a two hour tape.
• When STOP is pressed, the cylinder continues to
rotate for 5 minutes.
• When STOP is pressed, the cylinder stops.
• The search speed in SLP mode is 21 times
normal.
• The search speed in SLP mode is 21 times
normal.
• If the AC cord is unplugged and then plugged back
in, the Combination VCR will be in OFF condition.
• If POWER on the Combination VCR is pressed
OFF, the Combination VCR will be in Stop mode
when turned back on'
• If the DC cord is unplugged, and then plugged
back in: within one minute. Plav and Rec mode will
continue. All other functions will change to Stop
mode.
If unpluaaed for over one minute, the Combination
VCR will be in STOP mode when plugged back in.
AC Power Supply is Used DC Power Supply is Used
• If POWER on the Combination VCR is pressed
OFF, OTR (One Touch Recording) is continued.
• If POWER on the Combination VCR is pressed
OFF, OTR (One Touch Recording) will be
cancelled.
• If POWER on the Combination VCR is pressed
OFF, Timer Recording will be performed.
• If POWER on the Combination VCR is pressed
OFF, while a Timer Recording is in progress, the
Timer Recording will be cancelled.
• If POWER on the Combination VCR is pressed
OFF during rewind, the power will shut off but the
rewind will continue (Memory Rewind.)
• If POWER on the Combination VCR is pressed
OFF during rewind, the rewind is terminated and
the Combination VCR shuts off.
WARNING:
• There may be an excessive drain on the battery if the Combination VCR is used along with, such
power consuming things as fog lamps, air conditioner, power windows, etc.
• Never watch or operate the Combination VCR while driving a vehicle.
• Avoid leaving the Combination VCR in places of extreme heat, such as inside a hot vehicle, or in
direct sunlight as this may damage the Combination VCR.
39