Panasonic KX-F1000NZ - Manual (Page 49)

| i_ luj II
Recording image is faint. •The sender transmitted a faint document. Request them to transmit a
clearer copy of the document.
•The thermal head is dirty. Clean it (see page 53).
A blank sheet is ejected after the
received documents are printed
out.
•The receiving reduction rate is not programmed correctly. Program
the proper reduction rate (see page 37).
Operation in EXT. TAM mode
1 cannot receive documents
automatically. •Your greeting message on the answering machine is too long.
Shorten the message (up to 10 seconds).
•There are too many rings on the answering machine. Set to 1 or 2
rings.
•The silent detection feature is deactivated. Activate this feature (see
page 23).
1 cannot receive voice messages. •Check that the answering machine is turned on and connected to the
facsimile unit properly (see page 21).
•Set the number of rings on the answering machine to 1 or 2.
1 cannot retrieve voice messages
recorded on the answering
machine from a remote location. •The remote access code on your answering machine is the same as
your remote fax activation code or junk mail prohibitor ID. Set a
different number for each code/ID.
•You did not program your remote TAM activation code in your
facsimile unit correctly. Program the same code that is programmed
on the answering machine (see page 22).
The greeting message on your
answering machine is interrupted
halfway and the caller cannot
leave a voice message.
•The greeting message has a silent pause longer than 4 seconds.
Shorten the silent pause in the greeting message.
1 pressed the remote access code
to access the answering machine
remotely, but the line was
disconnected.
•The code may include “#” which is used for certain features provided
by the telephone company. Change the code on the answering
machine to another number which does not include then program
the same code into the facsimile unit (see page 22).
Copying
-
---------
A dirty pattern or black line
appears on the copied documents. •The glass or rollers are dirty. Clean them (see page 53).
Copied image Is distorted. •The thermal head is dirty. Clean it (see page 53).
The document is not copied
properly.
•The film is not inserted correctly. Insert it correctly (see page 54).
A paper jam occurs during
copying.
--- ---------------------------------------------
•The film is not inserted correctly. Insert it correctly (see page 54).
49