Setting monitor volume, Setting ringer volume, Setting monitor volume setting ringer volume – Panasonic Panafax UF-322 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A^usttogV^lipai«
You can adjust the monitor volume and ringer volume on your machine. The built-in speaker enables you to hear
the dial tone, dialling signals, and busy tone. The ringer sounds when your machine receives a call.
Setting Monitor Volume
You can adjust the volume by using both
1
CLEAR
I
and
I
SET
I
.
The following describes the method of using I CLEAR
I
and
1
SET
1
TEUDIAL
You will hear the dial tone through the speaker.
CLEAR
MnuiTno f------<
MONITOR
VOL
or
repeatedly to raise the volume.
MONITOR
VOL
L _
SET
repeatedly to lower the volume.
* DIALLING *
1
MONITOR VOLUME
LOW IMIIII
HIGH
MONITOR VOLUME
LOW
HIGH
3
® STOP
Setting Ringer Volume
The ringer volume is located on the upper left of the handset cradle.
Move the switch to a desired position, either high, low or off.
m
iJ Note:
You can also adjust the volume of the key touch tone and the volume of the buzzer in Fax Parameter
No. 10 (KEY/BUZZER VOLUME), (see page 33)
21