Panasonic TU-DST51 - Manual (Page 26)

G etting S t a r ted
Step 3e. Digital 8VSB Cable/Analog Cable with DTV-Compatible TV
Follow this diagram if you have a DTV-compatible TV, cable service providing 8VSB
digital cable and you want to receive digitai cabie channeis through the STB and
anaiog cable channels through the cable box (or through the TV if you have no cable
box).
Note; The STB is able to receive DTV signals from your local cable provider only if they are
transmitted in the 8VSB modulation format approved by the FCC for DTV
transmission. Also, your cable provider may elect to transmit in the 8VSB format for
only a limited period of time. Please contact your cable provider to determine if
8VSB modulation is available
Optional Cable Box
NOTE: ANTENNA, SPLITTER, CABLE
BOX, RF CABLES AND AUDIO CABLES
NOT INCLUDED
evSB signal
Panasonic!’
DiGiTilL ti DECOOER
o
MTSC INPUT
w
ATSC/DTV
INPUT □
WItfkaiTi fbitTIK
niifiuTiMgiMtiiici 1
'UtnulKM'M ht*rk» IrOm 0«lb| Litgrtlerlai. I
1
OnlB)', ‘i>C‘V ■<<« l»f Ira I ki K iiii U i I
1
«r DelEy Liberilanii. CanH^tniiil Unpuoira'^l'a
1 1
Q19S2'199r Deiav LibQ'iiaribl. lac RH »can rtikrvifl.
1 1
1
DIGITAL 8VSB CABLE/ANALOG CABLE RECEPTION WITH
DTV-COMPATIBLE TV SETUP
Procedure
• Connect the cable from the wall jack to the splitter using a standard RF cable with coaxial
connectors.
• Connect one splitter output to the STB ATSC/DTV input jack using a RF cable.
• If using a cable box, connect the other splitter output to the cable box ANT (antenna) IN
jack using a RF cable. Connect the cable box ANT (antenna) OUT jack to the DTV-
compatible TV ANT (antenna) IN jack using a RF cable.
• If not using a cable box, conned the other splitter output to the DTV-compatible TV ANT
(antenna) IN jack using a RF cable (not shown).
• Follow directions in Getting Started section to connect the STB to a DTV-compatible TV.