DVR systems NVR60xx Series - Manual (Page 186)

•
Operator: The Operator user level has permission of Two-way Audio in Remote Configuration and
all operating permission in Camera Configuration by default.
•
Guest: The Guest user has no permission of Two-way Audio in Remote Configuration and only has
the local/remote playback in the Camera Configuration by default.
User s MAC Address: The MAC address of the remote PC which logs onto the NVR. If it is configured
and enabled, it only allows the remote user with this MAC address to access the NVR.
4. Click the OK button to save the settings and go back to the User Management interface. The added new
user will be displayed on the list, as shown in Figure 13. 7.
Figure 13. 7 Added User Listed in User Management Interface
5. Select the user from the list and then click the button to enter the Permission settings interface, as shown
in Figure 13. 8.
Figure 13. 8 User Permission Settings Interface
6. Set the operating permission of Local Configuration, Remote Configuration and Camera Configuration for
the user.
Local Configuration
•
Local Log Search: Searching and viewing logs and system information of NVR.
•
Local Parameters Settings: Configuring parameters, restoring factory default parameters and
importing/exporting configuration files.
•
Local Camera Management: The adding, deleting and editing of IP cameras.
•
Local Advanced Operation: Operating HDD management (initializing HDD, setting HDD
property), upgrading system firmware, clearing I/O alarm output.
•
Local Shutdown Reboot: Shutting down or rebooting the NVR.
Remote Configuration