DVR systems NVR60xx Series - Manual (Page 131)

9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
NVR-6064
NVR-5816P8/7632P8
Figure 9. 1 Network Settings Interface
Note: Dual-NIC configuration is only applicable for NVR-6064 series NVR.
3. In the General Settings interface, you can configure the following settings: Working Mode, NIC Type, IPv4
Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.NFor the 7600/ NVR-5816P8 series NVR, you need to
configure the internal NIC address, so that IP addresses are assigned to the cameras connected to the PoE
interfaces.
Note: The valid value range of MTU is 500 ~ 9676.
4. After having configured the general settings, click to save the settings.
Working Mode
There are two 10M/100M/1000M NIC cards provided by NVR-6064series device, and it allows the device to
work in the Multi-address, Load Balance and Net-fault Tolerance modes.