Dillon Quick-Check Wire Tension Meter (Red) - Manual (Page 24)

24 Quick-Check Red User Instructions
l Enable Auto-Shutdown - Auto-Shutdown powers off the instrument
automatically. If Yes is chosen, the following options will be displayed:
Shutdown Timer (Min): Program to shut down after a period of
inactivity.
Shutdown Type: Select a method of shutdown.
Fixed: Set the amount of time for the unit to shut off
No Load: No load of the tension meter
No Change: No change in weight
PtFmt:
l Default Print Format
l Print time and date
Misc:
Press this softkey to set the following:
l Flash - Enables or disables the momentary blinking of the display to
acknowledge a key press.
l Zero - Enables the use of the Zero softkey to clear a peak tension value.
l Contr - Press this key to adjust the contrast of the LCD display. Press the
Up soft key to lighten the contrast. Press the Down softkey to darken the
contrast.
There is a keypad shortcut for increasing and decreasing contrast. While
in normal display mode press the Arrow key and the 2nd softkey
simultaneously to increase contrast. Press the Arrow key and first softkey
simultaneously to decrease contrast.
l Blite - Press this key to adjust the backlight brightness and sleep timer
functions.
Inten- Backlight intensity can be set to a value of 1 - 10. Default
backlight value is 1.
Press Arrow key and F4 simultaneously to increase intensity.
Press Arrow key and F3 simultaneously to decrease intensity
Mode- Select Backlight to operate as always “On”, “always Off” or
the backlight can operate from a configurable “Timer”.
If set to Timer, the operator will be asked to enter the Time in
Seconds, after motion stops that the backlight will shut off.
The next selection will allow the user to configure if motion resets
timer. Choose Yes or No to have motion reset the Timer which
turns off the backlight.
Use of the backlight will affect battery life.