Dillon Quick-Check Wire Tension Meter (Red) - Manual (Page 23)

Quick-Check Red User Instructions 23
Setup
Press the Setup softkey and you will see these choices; Power, PtFmt, Misc, About,
Test and Clock. These are described below:
Figure 3.7 Setup Menu
Power:
Use this to set power management features
l Peak Capture Rate - Select a Peak Capture Rate by using the Sel keys to
scroll through the choices. Choices are 100Hz - Normal, 1kHz - High
Speed, and 10Hz - Battery Saver (default). Press Enter to accept the
displayed setting.
Setup
Power PtFmt Misc. About Test
Batt A-D Disp Keys Comm Setpts
Setpt1 Setpt2
Cell COM1
Press KEY to
test. Press ESC
key to exit
View Counts and
Cal. factor Run display test View Battery
Voltage
Device Calib. 0.Load Zero Ntwrk
View Radio
information
View Dead load
Analysis
View Over load
counter and log
Points Re-Cal Print
Print Calibration
report
To view when
calibration is due
View all
Calibration
points
Display Device
info, SN, FW and
PN
Flash Zero Contr BLite
Inten Mode
Selected
Backlight ON,
OFF or Timer
operation
If Timer enabled
then: Enter time
in Seconds
Choose Motion
Reset Timer:
(Yes or No)
Choose backlight
intensity: 1- 10
Adjust Contrast
Up or DOWN
Choose Zero Key
clears Peak:
(Yes or No)
Set AZT (div): .5
Set Motion
Range (div): 1
Enable Key
Blink:
(Yes or No)
Choose default
print format: 1 - 5
Set Filter
(*40)
Date/Time
(Enabled,
Disabled)
Peak Capture Rate:
(100Hz – Normal),
(1KHz – High Speed),
(10Hz – Battery Saver)
Enable Auto-
Shutdown:
(Yes or No)
RADIO
Clock
Be aware that 1kHz - High Speed mode will consume more battery power.