Dillon Quick-Check Wire Tension Meter (Red) - Manual (Page 10)

10 Quick-Check Red User Instructions
2 Introduction
This manual covers the setup and operation of the Quick-Check Clamp Line
Tensiometer from Dillon. The Quick-Check is a simple, accurate strand dynamometer.
It is can be clamped onto a cable, accurately determine the wire tension and be
removed in seconds.
The Quick-Check can handle multiple wire diameters, it can display live tension, dual
live/peak tension, average tension captured from several tests, and a check-tensioning
graphical display.
With its battery-powered electronic interface, setup and operation is made simple with
on-screen prompts.
This manual covers the following:
l Unpacking
l Setup
l Operation
l Maintenance
l Troubleshooting
2.1 Unpacking
When you receive your Quick-Check, unpack it and inspect the container and the
instrument for any damage. Report any problems to the shipping company immediately
and save the packing materials.
Insert 2 AA batteries into the battery compartment, shown in Figure 2.1 . Your Quick-
Check probably comes from the factory with the proper sheave size installed and
calibrated for your application. If not, follow the setup directions later in section 3.0
Configuration Mode and section 4.0 Changing Sheaves.
The Quick-Check is shown in Figure 2.1 with the different parts labeled.
Figure 2.1 Quick-Check Parts
Lever arm
Front panel
Battery compartment
Sheaves
Support arm