Dillon Quick-Check Wire Tension Meter (Red) - Manual (Page 18)

18 Quick-Check Red User Instructions
Store
Press the Store softkey to store and add a displayed tension to the average of other
entered readings. Follow the onscreen prompts.
When Multi Leg/Wire is enabled in Log>Setup menu, each leg is identified by a letter
rather than a number (A - I). Each tension wire (guy wire) is identified by a number.
When the Store softkey is pressed, leg with be displayed. If more than one leg, use the
Sel keys to select the desired Leg. Press Enter to go to the wire selections. Use the
Num keys to select the wire number. Press Enter to store the tension reading. Refer
to page
21 for more details.
Press the key to move to the next set of softkeys.
Units
Press this key to set the Quick-Check for displaying:
l Force in lbf, kgf or N
Log
Log mode is used to log/record force and peak data. Press this softkey to view the
number of records logged. This can be done on each lift, during a timed duration, during
an overload or on Print key operation.
Figure 3.5 Log Menu
Log
Setup ID Send Clear
Log Mode
Disable On Print On Lift Timed Overload
Auto ID increment
(Enabled,
Disabled)
Auto ID prompt
(Enabled,
Disabled)
Log rate (sec)
1
Log count
(1 to 255)
Auto send
(Disabled,
Enabled)
Comm port
(Disabled, Cell,
COM1, RADIO)
Threshold%
10
Re-arm%
2
Auto ID increment
(Enabled,
Disabled)
Threshold%
5
Re-arm%
2
Holdoff Seconds
1
Comm port
(Disabled, Cell,
COM1, RADIO)
Comm port
(Disabled, Cell,
COM1, RADIO)
ONLY APPEARS
IF AUTO ID
INCREMENT IS
DISABLED
Auto send
(Enabled,
Disabled)
Comm port
(Disabled, Cell,
COM1, RADIO)
Multi Leg/Wire
Max Legs
(0-9)
Max Wires
(0-30)
Comm port
(Disabled, Cell,
COM1, RADIO)