Dillon GTX Plus Force Gauge - Manual (Page 11)

GTX-Plus Series User’s Manual REV 2.1 11
1.1) AUTO-OFF An Auto-off feature can be enabled to conserve
battery power where the gauge powers down after 5,10 and 15 minutes
(depend on Auto-off time) since the last key press. The AO will appear in
the main display if you activate this feature.
To access AUTO-OFF menu, Press UP and DOWN to move the
cursor point to AUTO-OFF and press the ENTER key the display will show
the auto-off menu page. Press ESC key to return the setup menu page.
AUTO-OFF MENU
1) OFF
2) 5 MINUTE
3) 10 MINUTE
4) 15 MINUTE
Figure 6 Auto-Off Menu
Use UP and DOWN key to move the cursor. Press the ENTER key
to select auto-off option and return to setup menu page.
1.2) PASS-FAIL the Pass-Fail feature used to set a defined
acceptable maximum and minimum forces gap for measuring. It activate
by setting the lower level and upper level forces limit If the forces value
is within the gap level, the display will show message PASS. Any reading
values outside this gap (higher or lower), the display will show message
FAIL. If you activate this feature the PF symbol will display on main
display.
To access PASS-FAIL menu, Press UP and DOWN to move the
cursor point to PASS-FAIL and press the ENTER key the display will show
the Pass-Fail menu page. Press ESC key to return the setup menu page.
Use LEFT ARROW keys to move cursor point to the desired value.
Use UP and DOWN keys to change the value, press and hold to scroll
values. Use RIGHT ARROW key to change the unit. Press ENTER to save
setting and return to Setup menu page.
*Pass-Fail feature will
automatically disabled if you set LOWER
and UPPER = 0 N.
*LOWER must be less than the
UPPER.
PASS FAIL MENU
UPPER = 2.5 N
LOWER = 1.0 N
Press Zero key to
Reset value.