CANOGA PERKINS 9161 Network Interface Device - Manual (Page 38)

9161 Network Interface Device User’s Manual Using the Software
Managing Security
26
c. Use to toggle through the Notification Types to set the security level for
the destination, from V1-Trap through V3-Inform
d. If V1-Trap, V2-Trap, or V2c-Inform or V3-Inform is the Notificaiton Type:
• Enter the community name, up to 32 characters, and press
• Enter the SNMP Engine ID and press .
• Use to toggle through the Authentication Protocols; MD5, SHA,
or None, and press .
• Type an Authentication Password of at least 8 characters, press ,
then retype the Authentication Password and press again
• Use to select an Privacy Protocol; DES for MD5 or SHA, or
None, and press
• If the Privacy Protocol is DES, type a Privacy Password of at least 8 char-
acters, press , then retype the Privacy Password and press
again
• Use to toggle the Security Level to select No Auth/No Priv, Auth/
No Priv, or Auth/Priv and press
• Type in the number of times to try to resend the message if not acknowl-
edged between 0 and 10
• Type in how long to wait for an acknowledgement before retrying between
1 to 30 seconds
e. If V3-Trap is the Notification Type:
• Use to toggle through the usernames and press to select
• Press to cycle through the options for the Security Level, and
press to return to the Notification Destination Table screen.
6. To delete a destination, type 3 and press , then at the prompt, highlight the IP
Address for that Host and press . The host table appears again with your
changes.
7. To return to the System Menu, press .
V1-Trap: Unacknowledged message with SNMPv1 protocol
V2-Trap: Unacknowledged message with SNMPv2c protocol
V2-Inform: Acknowledged message with SNMPv2c protocol
V3-Trap: Unacknowledged message with SNMPv3 authentication and optional
encryption
V3-Inform: Acknowledged message with SNMPv3 authentication and optional
encryption