CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 60)

EdgeAccess Universal Chassis System
Table 4-12. Utilities Menu Options
Item Definition
1. Set Date and Time Change the time and date information for the modem if needed; if in
a chassis with a DMM, the DMM date and time overrides the L351
2. Reset Configuration
To Default
3. Reset Remote
Configuration To
Default
Restores all configurable settings to the defaults except for: date
and time; password; BOOTP; Telnet timeout
4. Remote Craft Port Enable or disable the console port on the remote module
5. Modem/Slip/PPP Baud
Rate
Select the baud rate, 9600, 19200, 38400, 57600, or 115200 bps for
the modem/SLIP/PPP serial port
6. Modem Initialization
String
The default string is AT
7. PING Generation Access the PING diagnostics screen
8. Static ARP Table Set or change specific IP and MAC addresses
9. Dynamic ARP Table View current IP and MAC addresses
4.10.1 PING Generation
Use the PING Generation screen to test the connection to a specific IP address. See Figure 4-33. To
use PING to check a connection, follow these steps:
1. From the Main Menu, type 7, Utilities, and press .
2. From the Utilities menu, type 7, PING Generation, and press .
3. At the PING menu prompt, set the PING parameters, and press .
• PING response received... indicates a good connection
• TIMEOUT: Unable to reach [IP address]... indicates a faulty connection.
4. To stop the PING , press .
--------------------------PING GENERATION-----------------------------
1) Ping Address : 0.0.0.0
2) Ping Count : 0
3) Start Pinging
Select [1-3]:
-------------------------------Messages-------------------------------
Figure 4-33. PING Generation Screen
4-36 L351 10/100BASE Media Converter