CANOGA PERKINS 1502 Domain Management Module - Manual (Page 27)

EdgeAccess Universal Chassis System
Set Up the Notification Destination for Traps
Use the Trap Notification/Destination Table to view and set up the destination for Trap messages.
In addition to setting the host address and port, you can set the security level for the notification,
then set values for various parameters, depending on the security level. For details on and values
for security parameters for your system, see the documentation for your network security system.
To access and update the Trap Notification/Destination Table, follow these steps:
1. At the Domain Management Module menu, type 7 , Trap Destination Table, and press
. The Trap Notification/Destination Table screen appears.
2. To add a destination, type 1 and press , or to edit an existing destination, type 3 and
press , then follow the prompts on the Edit Trap/Notification Type screen to enter
values, or press to cycle through options for these parameters:
• IP Address for the destination
• Trap Notification Port for the destination; Range is 1 to 65535; typically set to 162
• Notification Type sets the security level for the destination, from V1-Trap through
V3-Inform
V1-Trap: Unacknowledged message with SNMPv1 protocol
V2c-Trap: Unacknowledged message with SNMPv2c protocol
V2c-Inform: Acknowledged message with SNMPv2c protocol
V3-Trap: Unacknowledged message with SNMPv3 authentication and optional encryption
V3-Inform: Acknowledged message with SNMPv3 authentication and optional encryption
3. To finish setting up V1-Trap, V2c-Trap, or V2c-Inform notification, type the community
name, up to 10 characters, and press .
4. To finish setting up SNMPv3-Trap notification, press to cycle through the options
for these parameters:
• Security Name: The name of the user account at the DMM.
• Security Level: Can be "No Auth/No Priv" means no user authentication or encryption
for the message; "Auth/No Priv" means authentication by user name, but no encryption
for the message; "Auth/Priv" means authentication by user name and encryption for the
message.
5. To finish setting up SNMPv3-Inform notification, either type a value and press or
press to cycle through the options for these parameters:
• Security Name: Enter the name of the user account at the destination, up to 10 characters
• Engine ID: Enter the SNMP Engine ID at the destination; view it at the destination
configuration; 64 Hex characters.
• Authentication Protocol: Set how to authenticate the notification; can be MD5, SHA, or
None.
• Authentication Password: Enter the password that generates the authentication key for
the message if the authentication protocol is MD5 or SHA; 8 to 15 characters.
Model 1502 Domain Management Module 3-17