CANOGA PERKINS 1502 Domain Management Module - Manual (Page 17)

EdgeAccess Universal Chassis System
Table 6. IP Address Classes
Class First Octet of IP Address Default Subnet Mask
Class A 1-126 255.0.0.0
Class B * 128-191 255.255.0.0
Class C 192-233 255.255.255.0
*Address 127 is reserved for loopback.
The MAC or Ethernet hardware address for the DMM is fixed. If BOOTP is enabled during the
initialization process, it broadcasts BOOTP request packets until it receives a response from the
BOOTP server or you press to continue. If the DMM has a fixed IP address, disable
BOOTP. To assign an IP address to the DMM through the BOOTP request process, follow these
steps:
1. At the Domain Management Module menu, type 1 ; the System Configuration screen appears.
2. Check item 10, BOOTP.
• If it is set to "Enabled," reset the DMM to start the BOOTP process.
• If it is set to "Disabled," type
10 and press , then press to cycle between
Disabled and Enabled, and then press . The next time you reset the DMM, it will
start the BOOTP process.
3. To return to the Domain Management Module menu, press .
Manage Traps and Alarms
Traps are messages that require management attention and are routed to the Network Manager
and the DMM Alarm Log, but do not trigger alarms. Use the Trap Configuration screen to view
the current configuration and enable log only, send only, both log and send; or disable traps
individually or use the "Master Trap Control" to set all traps for the DMM. For a list of events
that trigger traps, see Table 7. To set up the traps, follow these steps:
1. At the Domain Management Module menu, type 5 , "Trap Configuration," and press .
2. At the Trap Configuration screen, type the number for a trap and press . See Table 7.
3. Press to cycle to Log Only, Send Only, Both Log and Send, or Disabled and press
.
4. To return to the Domain Management Module menu, press .
These selections do not affect how the CIM Major and Minor LEDs report alarms.
Model 1502 Domain Management Module 3-7