When the alarm sounds, Disabling alarms, Snooze timer – C. Crane WFR-28 FM-RDS User Manual

Page 67

When the alarm sounds

The buzzer or radio alarm will sound at the selected times for up to 60 minutes unless cancelled.

The volume used for the alarm will be as specified during the alarm setting procedure. If the radio

cannot connect to the specified radio station, the buzzer alarm will be used instead.

To cancel an alarm, press the

Standby button to return to standby mode.

The alarm icon will flash at the bottom of the playing mode displays, and the radio will

automatically switch back to standby mode when the 60 minutes have elapsed.

Note: If you have your earphone insert while the alarm is sounding, the sound of the alarm will

come out from your earphone.

Disabling alarms

1. To disable a single alarm enter the alarm setup menu and rotate the Tuning Control Rotary until

the desired alarm is highlighted on the display. Press the

Tuning Control Rotary to confirm.

. Rotate the

Tuning Control Rotary until the 'Enable:' option is highlighted on the display. Press

the

Tuning Control Rotary.

. Rotate the

Tuning Control Rotary to highlight 'Off' and press the Tuning Control Rotary.

. Rotate the

Tuning Control Rotary until the 'Save' option is highlighted on the display then

press the

Tuning Control Rotary to save the new setting.

The chosen alarm will now be disabled.

Snooze timer

1. The buzzer or radio alarm can be silenced for 5 minutes by pressing the

Alarm button. Should

you wish for a longer snooze duration this can be extended. Pressing the

Alarm button again

while the radio is snoozed will set the available snooze time to 5, 10, 15 or 30 minutes.

2. While the snooze timer is active the remaining snooze time is shown next to the flashing alarm

icon on the clock display.

3. In order to cancel the Snooze timer while the alarm is suspended, press the

Standby button.

The display will briefly show an 'Alarm Off' message.

SELECT

/SEEK

1-4