C. Crane WFR-28 FM-RDS - Manual (Page 12)

17. Once you have connected your radio to the network (and therefore also to the Internet) it will
display the main menu. Press the Tuning Control Rotary to put the radio in Standby mode.
It should then display the time as obtained from the Internet. If the time display is not correct
for any reason, it can easily be adjusted later, see ‘Manually setting the clock’.
If you have followed the steps on the preceding pages successfully, your radio will have
connected to your router, and then made a connection to the Internet and set its clock.
If this is the case, then you can try listening to radio stations via the Internet.
Note: To save the radio power consumption while your radio is powered with battery, the
radio will turn off fully when put into standby mode. As a result, if you switch off your radio
when your WFR-28D is power supplied with battery, next time when your radio is switched
on, the time on the screen will be reset and show as ‘00:00’ . However, as soon as the radio
connects with WiFi, the time will update automatically from the network.