C. Crane WFR-28 FM-RDS - Manual (Page 59)

5
GB
Presetting stations in DAB and FM modes
There are 5 memory presets each for DAB and FM radio. They are used in the same way for
each operating mode.
. Press the Standby button to switch on your radio.
2. Tune to the required radio station as previously described.
3. To store the station as a preset, press and hold the required Preset button (1 - 10) until the
display shows 'Preset stored'. The station will be stored under the chosen preset button.
Repeat this procedure as needed for the remaining presets.
4. Stations which are already stored in the presets may be over written by following the above
procedure.
Note: The radio station presets are retained in memory when the radio is switched off and
disconnected from the mains supply.
Recalling a preset in DAB and FM modes
. Press the Standby button to switch on your radio.
2. Select the required operating mode using the Mode button.
3. Momentarily press the required Preset button. Your radio will then tune to the station stored in
the selected preset memory. The chosen preset number is also shown in the lower area of the
radio display, e.g. 'P2'.
1
1 2 3 4 5
3
MODE
2 1
1 2 3 4 5
3