Fm radio – C. Crane WFR-28 FM-RDS User Manual

Page 54

FM Radio

Operating your radio in FM mode

1. Carefully extend the telescopic aerial and press the

Standby button to switch on your radio.

. Press the

Mode button as needed to select FM radio mode.

. Rotate the

Tuning Control Rotary and then press the Tuning Control Rotary. The displayed

frequency will increase. Your radio will scan up the FM band from the currently displayed

frequency and will stop scanning when it finds a station of sufficient strength.

4. The display will show the frequency of the signal which has been found. If RDS information is

available, after a few seconds the display will show the radio station name.

If you only hear hiss or interference, simply press the

Tuning Control Rotary to scan further.

Your radio may have found a spurious interference signal.

5. To find more FM stations press the

Tuning Control Rotary to repeat the scan operation. To scan

down in frequency, rotate the

Tuning Control Rotary and then press the Tuning Control Rotary.

Your radio will scan down the FM band from the currently displayed frequency and will stop

scanning when it finds a signal of sufficient strength.

6. When the end of the waveband is reached your radio will recommence tuning from the opposite

end of the waveband. Use the

Volume buttons to adjust the sound level as needed.

MODE

SELECT

/SEEK

3-5