BendixKing KLN 900 - Pilots Guide - Manual (Page 84)

3-57 Rev 2
CAUTION: The altitude alerting feature will only be
accurate if the altimeter baro correction is kept
updated. If altitude alerting is used, it is a good idea to
update the altimeter baro set on the ALT page each
time you make a change to the aircraft’s altimeter set-
ting.
The volume of the aural alarm tone is changeable on the
SET 9 page (figure 3-181). Press the left
C to activate
the left cursor and use the left inner and outer knobs to
select a desired volume between 00 and 99. Increasing
numbers increases the volume.
NOTE: The altitude alerting and height above airport fea-
tures can be disabled in the KLN 900 configuration module
during installation so that these features are not selectable
by the pilot. When this has been done the SET 5, SET 9,
and Altitude pages display OFF and cannot be changed. In
addition, the SET 5 and SET 9 pages display the following :
FEATURE DISABLED.
ALTITUDE |
ALERT |
VOLUME:
|
|
02 |
|
SET 9
Figure 3-181