BendixKing KLN 900 - Pilots Guide - Manual (Page 22)

2-7 Rev 2
2. Remove the new database card from its shipping
container. Note that the label on the card indicates which
side is up and which end to insert into the KLN 900.
Insert the new card into the front of the unit. When the
card is properly inserted, the card is flush with the front of
the KLN 900.
3. The container which was used to ship the new card
to you is used to return the old card back to Honeywell. A
return shipping label is included in the container.
Remove the backing from the label and place it in the
address position of the shipping container.
4. Insert the old card into the container. Peel off the
protective backing from the adhesive on the end flap of
the container. Press the flap against the adhesive to seal
the container.
5. Please return the old card promptly by mailing imme-
diately at any mailbox. No postage is required if mailed
from within the U.S. Users will be billed for cards not
returned and no additional cards will be sent until either
the old card or payment for the old card is received.
CRSR
MSG
OBS
NAV
FPL
MODE
TRIP
NAV
DT
ACTV
REF
CTR
BRT
OFF
PULL SCAN
D
CLR
ALT
NRST
ENT
CRSR
SAVE
Figure 2-9
2.4.2 Card Exchange Updating of the Database
1.
To exchange the KLN 900’s database card simply
turn the unit power off and remove the card from the front
of the unit. This is accomplished by depressing the ejec-
tion button on the right side of the card (figure 2-9) and
then pulling the card straight out of the front of the KLN
900. (figure 2-10)
CRSR
MSG
OBS
NAV
FPL
MODE
TRIP
NAV
DT
ACTV
REF
CTR
BRT
OFF
PULL SCAN
D
CLR
ALT
NRST
ENT
CRSR
SAVE
A
Figure 2-10