Webs-wm wall mounts – installation instructions, Faceplate led light, Blue light – Talkaphone WEBS-WM Wall Mount Emergency Phone Station with WEBS User Manual
Page 2: Auxiliary connections, Paging horns and amplifier

WEBS-WM Wall Mounts
– Installation Instructions
Copyright 2012 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 2 of 3
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
Faceplate LED Light
6. The LED light board operates on 12V up to 120V AC/DC and is non-polarity sensitive.
For the WEBS-WM, connect the Faceplate LED Light to the output of the power supply inside the unit.
Connect the input of the power supply 120VAC - 240VAC, 60Hz (wiring: brown - positive and blue -
neutral).
For the WEBS-WM-12 (12VDC power option), connect the Faceplate LED Light to the incoming
12VDC.
Blue Light
7. For the WEBS-WM connect the ETP-EL12/24 Blue Light power cable (white - positive and black -
negative) to 12VDC output voltage of the power supply provided inside the unit. Connect the input of
the power supply to 120VAC - 240VAC, 60Hz (wiring: brown - positive and blue - neutral).
For the WEBS-WM-12 (12VDC power option) connect the ETP-EL 12/24 to the incoming 12VDC.
Auxiliary Connections
8. When using the ETP-EL12/24 Blue Light with ETP-400 Series Emergency Phones, connect the
orange and black auxiliary control cable pair of the Blue Light to the orange and black wires of the
Emergency Phone. Refer to the Emergency Phone Manual for information regarding the programming
of your phone.
9. When using the ETP-EL12/24 Series Blue Light with VOIP-500 Series Emergency Phones, connect
the orange and black auxiliary control cable pair of the Blue Light to positions 3 and 4 (Aux. Output 2)
of the 6-pin connector plug of the VOIP-500 Series Phone. Refer to the Emergency Phone Manual for
information regarding the programming of your phone.
Paging Horns and Amplifier
10. The amplifier and horns are installed inside the unit prior to shipment. Connect the Amplifier Audio
Line Level Input to the Audio Line Level Output of either the VOIP-500 Series Emergency phones,
WEBS-CM-2 or the WEBS-ZPS.
11. Connect Amplifier Trigger pair (blue and orange) to either of the Aux. Outputs of the Emergency
Phone. Refer to the Emergency Phone Manual for information regarding the programming of your
phone.
12. For the WEBS-WM, connect the input power supply of the amplifier to 120VAC - 240VAC, 60Hz
(wiring: brown - positive and blue - neutral).
For the WEBS-WM-12 (12VDC power option), connect the amplifier to 12VDC (wiring: white - positive
and black - negative).