Talkaphone WEBS-RETRO-MT/R4 WEBS Retro Kit for ETP-MT/R OP5 Tower - Manual (Page 2)

WEBS-RETRO-MT/R4 Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 2 of 5
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
Figure 1. Installing the WEBS ® Tower Arm: (1) Strobe Light, (2) CCTV Camera, (3) Cap, (4) Tower Arm, (5) Cable Opening.
(B) Installing the Retrofit Tower Top
1) Fasten the Retrofit Top to the top of the tower with the help of the four 10-24 x 3/4" pan head
tamperproof screws provided.
2) Install the four WEBS ® loudspeakers by locking each one of them down with the retainer bracket,
starting with the bottommost speakers first (see Figure 2).
3) Pass the speakers wiring through the center hole at the bottom of the Retrofit Top and down to the
bottom of the tower.
4) Close the top of the retrofit tower top with its cap plate with the help of the four 10-24 x 3/4” pan head
tamperproof screws that were set aside.
5) Reconnect the strobe light wiring to the emergency phone and to its power source. Reconnect the
optional CCTV camera to the power source and to all other devices.