Talkaphone HS-RF-1 Wireless Headset User Manual
Page 2
HS-RF-1 Wireless Headset System Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 2 of 5
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
Plug the Base power Adapter into the wall outlet, then plug the power cord into the YELLOW labeled
connector on the bottom of the headset Base. The RED Power light on the left front of the Head set Base will
turn on.
IV. Charge the Headset for at least 20 minutes before using
Gently push the headset into the charging cradle as shown. The AMBER charge status light on the base will
flash to indicate the headset battery is charging. A solid light indicates full charge. A full charge will take
approximately 3 hours.
Connect RJ-11 to Headset port
of IW-HFM-4
- CU-16 Area of Refuge Surface Mount Command Unit (5 pages)
- CU-8 Area of Rescue Surface Mount Command Unit (5 pages)
- CU-8R Area of Rescue Flush Mount Command Unit (5 pages)
- EB-200 Base Station (9 pages)
- EC-2 Emergency Phone Consolidator (7 pages)
- EC-8 Emergency Phone Consolidator (16 pages)
- ETP-100E Flush Mount Emergency Phone (28 pages)
- ETP-CDMA-V CDMA Cellular Interface (6 pages)
- ETP-DMRK Punch-Down Block (2 pages)
- ETP-EL LED Blue Light (120V) (2 pages)
- ETP-EL12/24 LED Blue Light (12/24V) (3 pages)
- ETP-GSM GSM Cellular Interface (10 pages)
- ETP-MT/R Campus Emergency Phone Tower (2 pages)
- ETP-MT-72 Emergency Phone Tower (2 pages)
- ETP-MT/R AED Defibrillator Emergency Phone Tower (5 pages)
- ETP-MT/R OP SOLAR Solar Powered Emergency Phone Tower (25 pages)
- ETP-MT/R OP4D Radius Emergency Phone Tower with Dual CCTV Arm (2 pages)
- ETP-PDMK-2 Parking Deck Mounting Kit (1 page)
- ETP-PDMK-4 Parking Deck Mounting Kit (1 page)
- ETP-PM Pedestal Mount (3 pages)
- ETP-PMKT Pole Mounting Kit (2 pages)
- ETP-SM Emergency Call Box Surface Mount (2 pages)
- ETP-SME Surface Mount Extension (1 page)
- ETP-SMW Surface Mount for Wireless and Switched Power (1 page)
- ETP-TAL Talk-A-Lert (34 pages)
- ETP-UPS Back-up Power Supply (8 pages)
- ETP-WM Emergency Communication Wall Mount Station (3 pages)
- ETP-WM/E Economy Wall Mount Emergency Phone Station (2 pages)
- IW-HFM-4 Interview Window 4-Button Master (13 pages)
- K-S-112X Cradle Phone Sub-Station (3 pages)
- KB-LC-2 Single Channel Master (4 pages)
- KB-LC-2W Single Channel Master with Annunciator (4 pages)
- KB-ML-10 Ten Channel Master (5 pages)
- KB-ML-10WA Ten Channel Master with Annunciator (5 pages)
- MS-400 Flush Mount Sleeve (1 page)
- PBX-136 (5 pages)
- PCS-42-6 Power Charging System (42 Ah) (3 pages)
- PCS-84-10 Power Charging System (84 Ah) (3 pages)
- SA-1 Scream Alert (2 pages)
- VOIP-1 VoIP Interface (1 channel) (43 pages)
- VOIP-201C Surface Mount Single Button Compact IP Call Station (8 pages)
- VOIP-500 Single Button Native VoIP Emergency Phone (90 pages)
- VOIP-600E Single Button Emergency IP Call Station (94 pages)
- WEBS-CM-2 WEBS Communications Module (53 pages)