Connecting a talk-a-phone wall mount to a post – Talkaphone ETP-PMKT Pole Mounting Kit User Manual
Page 2
ETP-PMKT Pole Mounting Kit Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 2 of 2
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
Connecting a Talk-A-Phone Wall Mount to a Post
Connect the Wall Mount to the post before installing your Emergency Phone. Remove the Wall Mount cap. The
cap is attached to the wall mount using #10 spanner screws. If you do not have a driver, one is available from
Talk-A-Phone as part number 42834D. A hex bit is also available, part number 42834B.
Connect one 1-Bolt Flared Leg Bracket to each of the pre-drilled keyholes above the central conduit holes and to
each of the pre-drilled circular holes below the central conduit holes in the back of the ETP-WM wall mounting
accessory. Each Bracket comes with a bolt and washer, which are placed through the pre-drilled holes from
within the ETP-WM.
Use the enclosed Band and Buckles to fasten the ETP-WM to the post. Use the Band-It Tool to fasten the Bands
and Buckles. For details of how to use the Band-It tool, see the instructions that came with your tool. The tool is
available separately as model ETP-PMKT-TOOL.