Talkaphone ETP-GSM GSM Cellular Interface - Manual (Page 10)

ETP-GSM
– Cellular Interface
Installation Instructions
Page 10 of 10 Rev. 12/16/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement, sponsorship, or affiliation
with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
VI. Activation of Cellular Service
Select a local cellular service provider that supports GSM (e.g. AT&T, T-Mobile) and 3G voice service. Per the
aforementioned installation instructions, install an activated SIM card provided by the local cellular service
provider into the ETP-GSM Cellular Interface.
VII. Programming the ETP-400 Series Phone
The ETP-400 Series Phone requires specific programming for operation with the ETP-GSM Cellular Interface.
At minimum, the ETP-400 Series Phone should be programmed with the following codes:
* 4 **
* 13 * # *
* 14 * 3 *
* 18 * 5 *
* 24 * 0 *
* 27 * 0 *
* 55 *
* 56 *
* 58 * (optional)
* 72 *
* 103 *
For a full comprehensive list of programming codes, reference the Installation & Operation Manual for
Emergency/Information Phones.
NOTE: The hash or # appended after the (i.e. for the * 13 * # * code) is
only required if the Intelli-Voice option (V-Chip) is used on the ETP-400 Series Phone.