OFNA Racing Blazer SST - Manual (Page 32)

NOTICE:
9.5 BLAZER RTR KITS WILL COME WITH “SHAFT START #50000”
(same as Rotor Start). THEREFORE, A PULL START ENGINE IS NOT
USED AND THE SHAFT START FORCE BACK PLATE (#50010) IS
ALREADY INSTALLED.
BEFORE YOU CAN USE THE SHAFT START MOTOR HANDLE, YOU
MUST FIRST GET OR BUY A STANDARD 7.2 BATTERY PACK.
AFTER POWERING UP THE MOTOR HANDLE, INSERT THE SPECIAL
DOG BONE SHAFT AND TURN OVER THE ENGINE.
CHECK BEFORE STARTING:
1) IS THE FUEL LINE PRIMED?
2) IS THE CARBURETOR SET FOR BREAK-IN SETTINGS?
3) IS THE RADIO ON AND THROTTLE AND BRAKE LINKAGE
CHECKED AND OKAY TO START?
4) MAKE SURE RADIO AND CAR RECEIVER BATTERY ARE ON AND
WORKING WITH GOOD POWER.
5) PLACE THE GLOW HEATER ON PLUG.
6) HOLD THE TRUCK AND STARTUP THE ENGINE, BY PUMPING
THROTTLE SLIGHTLY. DO NOT HIGH REV ENGINE WHEN IT
STARTS, AT THIS TIME!
SHAFT START