Rane SR 4 - Manual (Page 24)

Manual-24
IS
Input Suggest
Suggests new level and selection. Resets the command state to No Operation.
If Auto Level is enabled, the level is updated and indicated by the encoder LED only if
the device’s level has not changed by someone turning the encoder. Otherwise, if Auto
Level is disabled, the level is updated and indicated by the encoder LED regardless of
encoder input.
If either Auto Selection is enabled (“knob push and turn” or “knob bump”), the selec-
tion is updated and indicated by the column of LEDs only if the device’s selection has
not changed by local encoder action. Otherwise, if neither Auto Selection is enabled,
the selection is updated and indicated regardless of encoder input.
Send: IS,n1,n2
Where: n1 is the suggested new level. The level range is [0, 31].
If n1 is zero, the level remains unchanged.
n2 is the suggested new selection. The selection range is
[0, 8]. If n2 is zero, the selection remains unchanged.
Example: IS,3,5 suggests a new level of 3 and a new selection of 5.
Response: n1,n2,"OK"
Where: n1 is the current level. The level range is [1, 31].
n2 is the current selection. The selection range is [1, 8].
Example: 3,5,"OK" means the current level is 3 and the current
selection is 5. This means the suggested level and selection were
updated. A response of 10,5,"OK" means the current level is 10
and was last changed by someone turning the encoder and the
current selection was updated to 5.
ISR
Input Suggest Raw
Same operation as IS Input Suggest except ISR returns the command state byte and
button time. Suggests new main level and second level. Resets the command state to
No Operation.
If Auto Level is enabled, the level is updated and indicated by the encoder LED only if
the device’s level has not changed by someone turning the encoder. Otherwise, if Auto
Level is disabled, the level is updated and indicated by the encoder LED regardless of
encoder input.
If either Auto Selection is enabled (“knob push and turn” or “knob bump”), the selec-
tion is updated and indicated by the column of LEDs only if the device’s selection has
not changed by local encoder action. Otherwise, if neither Auto Selection is enabled,
the selection is updated and indicated regardless of encoder input.
Send: ISR,n1,n2
Where: n1 is the suggested new level. The level range is [0, 31].
If n1 is zero, the level remains unchanged.
n2 is the suggested new selection. Selection range is [0,
8]. If n2 is zero, the selection remains unchanged.
Example: ISR,3,5 suggests a new level of 3 and a new selection of
5.
Response: n1,n2,n3,n4,"OK"
Where: n1 is the current level. The level range is [1, 31].