Canon C75 - Manual (Page 76)

6-8 Speed Dialling Chapter 6
4 Press Coded Dial.
5 Use the numeric buttons to enter the two-digit
code assigned to the number you wish to fax.
• The number registered under that coded speed
dialling code is displayed.
• If you enter the wrong code, press Stop. Then
press Coded Dial and enter the correct code.
• NO TEL # appears if no fax number is assigned
to the coded speed dialling code you entered.
6 Press Start (Start/Scan) to begin scanning
for sending, or wait a few seconds for the unit
to begin scanning automatically.
• If you prefer the unit never to scan a document
automatically after a few seconds, disable the
TIME OUT setting. ( → p. 14-6)
n • You can also use coded speed dialling to send a document to more than one destination at a
time. ( → p. 7-14)
• To dial a telephone number registered for coded speed dialling, simply lift the handset, press
Coded Dial, and enter the two-digit code.
Using Coded Speed Dialling
To use this feature, you must first register a number for coded speed dialling. (
→
p. 6-6)
Follow this procedure to send documents using coded speed dialling:
1 Open the document tray (MultiPASS models
only).
2 Adjust the document feed lever for the
document you are loading. (
→
p. 4-2)
3 Prepare the document and load it, face down,
in the ADF. (
→ p. 4-4)
• For colour sending, press Colour/B&W (Color/
B&W) to turn on its light. ( → p. 7-3)
• To adjust the resolution and contrast,
→
pp. 7-4,
7-5.
(Currently used memory)
(Standby to scan)
Ex:
Ex:
MEMORY USED 0%
DOCUMENT READY
A
A01
TEL=03 3758 2111
Ex: