Garmin GPS 65 - Manual (Page 66)

To install above dash or overhead»
The gimbal bracket can be mounted on a flat surface iising appropriate
screws (standard 3/16" or M6 screws are recommended; lei^fh must be
selected depending on panel thickness). The GPS 65 can quickly be
installed by sliding the threaded portion of the knobs into the slots in the
gimbal bracket and tightening the knobs. The GPS 65 can easily be
removed to prevent theft by loosening the knobs and sliding the unit out
of the gimbal bracket as shown below.
To flush mount.»
* Make a rectangular cutout in the panel that is 84mm (3.30 inches)
horizontally by 119.5mm (4.70 inches) vertically.
> Insert the GPS 65 into the cutout.
‘ Thread the knobs into the sides of the GPS 65 from behind the
panel (do not ftdly lighten knobs).
C-6