Garmin GPS 65 - Manual (Page 41)

To set a proximity waypoint.»
' Select the Proximity Waypoint Page with the PROX softkey.
’ Select a blank waypoint name field with the arrow keys.
‘ Enter the waypoint name, (NOTE: Ifneither the waypoint name
nor the location exists in memory, the Waypoint Definition Pгlge
will be displayed. Youmustthenenterthewaypointlocation. See
Section 3.4 to create a waypoint.)
• IVessENT.
- Enter the proximity alarm distance.
* Press ENT to enable proximity alarm.
If the newly created proximity alarm circle overlaps with an existing
proximity alarm circle, you will be informed of the overlap with the
message “Proximity Overlap”. As lon^ as the overlap remains, this
message will be displayed each time the GPS 65 is turned on. (WARNING:
If you enter the overlap area, the unit will only inform you of the neamst
waypoint.)
5.3 REFERENCE WAYPOINTS
In section 3.4, we discussed creation of waypoints by entering the
latitude and longitude position. Another way to create a waypoint is by
referencing an existit^ waypoint. By indicating the bearing and range
from a reference waypoint, the GPS 65 is able to compute a latitude and
longitude location for the new waypoint.
To create a waypoint by
referencii^ another». HPT:KMCI
N 39M7.960*
W094M3.080'
►«F:6flRMIN
6M=000* RN
h p t
Select the Waypoint Definition
Page with the
WPT softkey.
Highlight the WPT mime field and
enter the new waypoint name.
Press ENT.
Highlight the “>Ref:” field and enter the existing waypoint that
will be used as reference, (If the reference field is not currently
shown, highlight that cyclic field and press CLR until it is
displayed.)
Press ENT.
5-2