Dell PowerEdge 2600 - Manual (Page 20)

/K CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
2 Lift the system into position.
Using a minimum of two persons, eaeh person should plaee one hand on the front-
bottom of the system and the other hand on the baek-bottom of the system.
3 Tilt the front of the system upward while aligning the baek shoulder serews on the
sides of the system with the baek slots on the slide assemblies (see Figure 1-13).
Figure 1-13. Installing the System in the Rack
Engage the baek shoulder serews in the slot just behind the green slide-release lateh,
followed by the middle and front shoulder serews.
Push the system inward on the slide assemblies until the yellow system-release lateh
elieks into plaee, loeking the slide to the system’s middle shoulder serew (see
Figure 1-13).
Pull up on the green slide-release latehes and push the system into the raek.
Tighten the thumbserews on the raek front panel.
1-16 I R a c k I n s t a l l a t i o n G u i d e