Dell PowerEdge 2600 - Manual (Page 14)

Installing the VersaRails Slide Assemblies
1 At the front of the гаек eabinet, plaee a VersaRails slide assembly so that its mounting-
braeket flange fits between the marks or tape (or numbered loeation) on the raek (see
Figure 1-6).
The four holes on the front of the mounting braeket should align with four of the
holes between the marks you made on the front vertieal rail.
2 Install two 10-32 x 0.5-ineh flange-head Phillips serews in the mounting flange’s top
hole and the third-from-top hole (see Figure 1-6).
3 At the baek of the eabinet, pull baek on the mounting-braeket flange until the
mounting holes align with their respeetive holes on the baek vertieal rail.
3 Install two 10-32 x 0.5-ineh flange-head Phillips serews in the baek mounting flange’s
top and third-from-top holes to seeure the slide assembly to the baek vertieal rail.
5 Repeat steps 1 through B for the slide assembly on the other side of the raek.
6 Ensure that the slide assemblies are mounted at the same position on the vertieal rails
on eaeh side of the raek.
Figure 1-6. Installing the VersaRails Rail Assemblies
1-10 I R a c k I n s t a l l a t i o n G u i d e