Welch Allyn Holter Software PCH100 and PCH200, LAN - Installation Guide - Manual (Page 11)

11
4.2 Once logged on and the “Main Menu” is shown, click on the “Settings” button. From within the settings, click on the “System Settings”
button in the upper region so that the server can be configured. The System Settings will have an option for “LAN Configuration Settings”
as shown below.
4.3 Click on the “LAN Configuration Settings” button. The admin will now have to set the share name as well as user access that was given in
sections 3.3 and 3.4 above.
4.4 For the “Shared Folder Name”, use a UNC format name (\\Servername\FolderName\) as shown in the screen shot above. ServerName is the
name of the computer or IP address, FolderName is the name of the share given in step 3.3. Note that the last backslash (“\”) must be
entered.
4.5 Finally fill out the username and password fields using the system user account given permission in step 3.4 above. When this is complete
hit the OK button to continue.
4.6 A validation check will be performed and if the share is accessible and the user has access, there will be no error messages and the LAN
Configuration Settings will close saving the changes that were made.