Welch Allyn CP 150 12-lead resting electrocardiograph v.2.00.XX - User Manual - Manual (Page 28)

If Print preview on is selected in the ECG configuration settings, a single screen of
the ECG Report Print Preview appears. Touch Print to continue with the Auto ECG
test or touch Retest to discard the test and return to the previous screen.
10. If a Waiting for 10 seconds of quality data message appears, at least 10 seconds of
ECG data have been collected with excessive artifact. Time requirements in the
message may vary, based upon selected print format. Minimize the artifact, as
described under Troubleshooting. Then wait for the test to print. If necessary, you
can override the wait time and print the available data immediately, but the result
might be an incomplete or poor-quality test.
11. After the test prints, select the desired option: Reprint, Save, Retest, or Rhythm. If
the Auto Save setting is turned off, touch Save to save the test. Select one of the
following locations:
•
Local (internal memory)
• USB mass storage device (Any tests that you save to a USB mass storage
device can be retrieved only from a CardioPerfect workstation.)
• Workstation
• Remote file location
12. Touch Reprint to print the test again, touch Retest to discard the test and start over,
or touch Exit.
WARNING To avoid the risk of associating reports with the
wrong patients, make sure that each test identifies the
patient. If any report does not identify the patient, write the
patient identification information on the report immediately
following the ECG test.
Performing an Auto ECG test using the Search tab
CAUTION Patient data is not saved until the ECG test is completed.
Note The ECG configuration settings can be changed in the Settings tab. The
following settings may appear differently if the default settings have been
modified.
1. Touch the (Auto ECG) button. The Summary tab appears.
2. Search for patient.
The Search tab gives you access to patient data in the Saved tests directory or in
a connected database (CardioPerfect workstation or EMR).
• Touch the Search tab.
• Enter the Patient ID or Last name.
• Touch the OK button.
• Touch the Search button.
• Touch the patient's name or ID in the Patient name/Patient ID field.
• Touch the Select button.
• Touch the (Next) button to review or edit patient information.
• Touch the (Next) button again.
24 ECG tests CP 150 12-lead resting electrocardiograph