Carrier Access Adit 3104 - Manual (Page 44)

4-4 Adit 3104 - Release 1.6
Configuration
Web-Based Management
Web-Based Management
The web-based management interface allows you to control various system parameters. The interface
is accessed through a web browser.
To access the management console
NOTE: The following assumes that you have connected the PC to the LAN port of the Adit
3104.
1. Launch a web browser on your PC in the LAN to which the Adit 3104’s LAN port is connected.
Note: If connection to the Adit 3104 is to be through an Ethernet or T1 WAN, the remote admin
WAN access must be enabled with the following command sequence:
2. Type the Adit 3104’s IP address or name in the address bar.
Example: http://192.168.1.1.
Default IP address is http://192.168.1.1
Note: To display the current IP address of the systems, use the following CLI command:
#show interface ethernet 1 (LAN)
#show interface ethernet 2 (Eth WAN)
3. Login to the unit.
Enter User Name and Password. Note: These setting should be changed from the default
settings after the initial login.
Default user name is admin
Default password is admin 123
NOTE: After a few minutes of inactivity, the session will automatically timeout and the
operator will be required to log in to continue the session.
WARNING! I F YOUR U SER N AME AND P ASSWORD ARE SET TO THE DEFAULT SETTING , IT IS
RECOMMENDED THAT YOU MODIFY THEM FOR SECURITY PURPOSES .
Command Description
Username: admin
Password: ******** Log into the system (username and password).
Adit 3104> enable Enter the Privileged mode.
Password: ******** Enter password for the Privileged mode.
#configure terminal Enter the Configuration mode.
(config)# remote-admin web
primary-port enable
Enable remote web admin.