Torbal AGC Series Manual - Manual (Page 59)

Instruction Manual - TORBAL AGC Series
9. Once an accurate piece count has been taken, the container and its contents may be removed
from the scale. After the container with the counted pieces has been removed, the scale will
indicate the count is finished and that a new count may be initialized by pressing the “C” key.
The command “ ---, COUNT FINISH, TO START COUNT PRESS C will appear on the display
sequentially. To start a new count press the “C” key.
Note: If too many pieces have been placed into the container, remove the excess while the
container is still on the scale’s pan. You may also remove the container from the pan, remove
the extra pieces, and place it back on the pan to recheck the count. This may be performed
while command “ ---, COUNT FINISH, TO START COUNT PRESS C” is displayed, but before
pressing the “C” key. Once the “C” key is pressed the counting operation will reset.
To exit parts counting and switch to a different function, press “C” to clear the current function
and then press “Function” to select a different function (follow Steps 1 through 3 from Chapter
8 on page 50).
59