Torbal AGC Series Manual - Manual (Page 35)

Instruction Manual - TORBAL AGC Series
2. Commands tot On and tot OFF will be displayed sequentially. To enable totalizing and
proceed with configuration press the “T” (YES) key when tot On is displayed. If the function is
already enabled and you wish to disable it, press the “T” (Yes) key when tot OFF is displayed.
3. The totalizing function can operate in two different operating modes: automatic, and manual
(see Table 7.1.3.F). The operating modes will scroll once the function is enabled. To select a
desired operating mode for the totalizing function, press the “T” (YES) key while the mode is
displayed. I.e. to enable automatic totalizing, press “T” (YES) when AUTO is displayed.
4. After enabling the totalizing function, DONE will be displayed, indicating that the function has
been configured and it is ready to use. To use the function follow the directions in Chapter 8.
To exit the mode menu, use the “C” key.
35